Publicidad
Idiomas disponibles
Idiomas disponibles
Reading out the work and
error log
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN.
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Use the arrow buttons (6) to select "In-
formation".
6. Use the arrow buttons (6) to select "Er-
ror log" or "Work log".
The error and work log can be
read out here.
7. Press the back button (5) to return to the
main menu.
Charging
Do not expose the battery to ex-
treme conditions such as heat and
shocks. There is a risk of injury from leak-
ing battery fluid! In case of contact with
eyes or skin, rinse the affected sites with
water or neutralizer and seek medical at-
tention.
Only charge the battery with the
enclosed power adapter or an
approved Parkside X 20 V series
charger.
• Charge the battery before using it for
the first time.
• If the operating time is considerably
shortened despite charging, this shows
that the rechargeable battery is deplet-
ed and must be replaced. Only use an
original battery purchased from custom-
er service.
• Always comply with the latest safety
information, as well as the regulations
and information relating to environmen-
tal protection.
• Defects resulting from improper han-
dling are not covered by the guaran-
tee.
Charging the battery
The lawn mower automatically returns to
the charging station when it has a low
charge status. To do so, the lawn mower
locates the nearest boundary wire and fol-
lows this in a clockwise direction.
You can also place the lawn mower
in the charging station yourself.
Risk of injury! Press the STOP button
(9) before picking up the mower!
After the battery is fully charged, the
charging process stops and the lawn mow-
er switches to standby mode.
Graphical symbols on the charging
station
LED illuminated red:
Battery charging
LED illuminated green:
Battery charged
LED not illuminated: Charging station not
connected to the power
Checking the charge status
of the battery
You can check the charge status of the
lawn mower on the display at any time.
GB MT
LED flashing green:
Boundary wire dam-
aged or incorrectly
connected
63
Publicidad
