Pioneer XR-P670F Manual De Instrucciones página 52

PLAYING TAPES
52
: Indicates the side of the tape.
: Indicates the number of the track.
: Indicates the leader part of the tape.
: Indica la cara de la cinta.
: Indica el ndmero de la cancién.
: Indica la parte de cinta quia.
: Bret h
: Brea
: eS SR
The label printed side
is on the right.
El lado impreso de la
etiqueta se
encuentra sobre la
derecha.
RRS HAA -
<ARE7096>
En
A.S.E.S. (Auto Synchro Editing System)
mg What is A.S.E.S.?
@A.S.E.S. is a special function which automatically programs
the recording of CD tracks, so that the track which is only
partially recorded at the end of cassette side A is recorded
again in full at the beginning of cassette side B.
eWhen the A.S.E.S. function is used, if the playback mode
has been selected on the CD player, recording will be
performed in the sequence of the playback mode:
ALL : All discs recorded A.S.E.S.
SINGLE : Only the displayed disc is recorded A.S.E.S.
PROGRAM §: The selected tracks only are recorded A.S.E.S.
1. Load discs in the CD player. (Refer to page 34.)
eUse the program function to record tracks in a specific
order. A.S.E.S. will not function in the DISC ALL PROGRAM.
eWhen recording begins with a specific disc, use the DISC
SELECT button to select the disc number.
e Never insert more than one disc at a time into one rack slot.
This can scratch or damage the discs.
2. Press the CD function button.
Play starts automatically, so be sure to press the STOP
button.
3. Load a tape for recording into TAPE II.
e@ Recording is in the forward direction.
e Wind the tape past its leader portion so that the magnetic
surface is exposed. (Refer to page 22.)
4. Set the DOLBY NR ON/OFF button to the desired noise
reduction mode.
5. Select "ASES 1" or "ASES 2" with the ASES button.
Each time you press the button, the mode changes as follows:
ine ASES 1 ———» ASES 2
off poe!
ASES 1:
Perform procedure 6 > A.S.E.S. operation starts.
ASES 2:
Enables A.S.E.S. with the first track only of each disc.
6. Press the START button (<¢ > ).
A.S.E.S. starts.
To cancel the A.S.E.S.:
Press the STOP (m) or REC/STOP (e/m) button.
NOTES:
e By setting the CD player for all-track repeat in one of the disc
modes, you can record a tape fully without leaving any
remainder (repeat A.S.E.S.).
e@ During use of the A.S.E.S. function, near the end of a tape the
CD player may skip to the next track, or the CD may be
interrupted after ending its play. In this case, record the
remaining tracks manually, without use of the A.S.E.S. function.