IMPORTANT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The
lightning
flash
with
arrowhead,
within
an
CAUTION:
equilateral triangle, is intended to alert the user to the
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
presence of uninsulated "dangerous voltage" within the
NOT
REMOVE
COVER
(OR BACK).
NO
USER-
product's enclosure that may be of sufficient magnitude
SERVICEABLE
PARTS
INSIDE. REFER SERVICING
to constitute a risk of electric shock to persons.
TO QUALIFIED SERVICE PERSONNEL.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
[FOR U.K. AND EUROPEAN MODELS]
The following caution label appears on your unit.
Location: rear of the unit
CAUTION
This product contains a laser diode of higher class than 1. To
ensure continued safety, do not remove any covers or attempt
to gain access to the inside of the product.
Refer all servicing to qualified personnel.
CLASS 1
LASER PRODUCT
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
{FOR U.S. MODEL]
CAUTION
e Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
e@ The use of optical instruments with this product will increase eye hazard.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiates radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
POWER-CORD
CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your
hands are wet as this could cause a short circuit or electric
shock. Do not place the unit, a piece of furniture, etc., on the
power cord, or pinch the cord. Never make a knot in the cord or
[ THE POWER SWITCH IS SECONDARY CONNECTED AND
THEREFORE DOES NOT SEPARATE THE UNIT FROM MAINS
POWER IN STANDBY POSITION.
This product is for general household purposes. Any failure
due to use for other than household purposes (such as long-
term use for business purposes in a restaurant or use in a car
or ship) and which requires repair wil] be charged for even
during the warranty period.
2
<ARE7096>
En
tie it with other cords. The power cords should be routed such
that they are not likely to be stepped on.
A damaged power cord
can cause a fire or give you an electrical shock. Check the power
cord once in a while. When
you find it damaged,
ask your
nearest PIONEER authorized service center or your dealer for a
replacement.