Stiga BC 500 Li 48 Manual De Instrucciones página 172

2. 3, 4 -point blade: metal disc cutting
means (in the box).
D. Cutting means guard: it is a safety device
which prevents objects drawn up by the
cutting means from being hurled away from
the machine.
E. Front hand grip: semi-circular shaped, it is
used to handle the machine and is equipped
with a leg guard.
F. Rear hand grip: used to handle the
machine and equipped with the main on/off/
acceleration control buttons.
G. Handle bar: "cow horn" handle bar placed
transversely to the rod and asymmetrically to
it; used to control the machine and equipped,
on the right hand side, with the main on/off/
acceleration control buttons.
H. Leg guard: a safety guard that prevents
accidental contact with the cutting means
during use.
I. Harness: device made up of a fabric belt
which, placed over the shoulders, helps to
support the weight of the machine during
work.
1. single strap
2. double strap
J. Connection point (of the harness): where
the harness is connected to the machine.
K. Blade protection (for machine transport and
handling): protects against accidental contact
with the cutting means that can cause serious
injuries.
L. Battery (if not supplied with the machine, see
par. 15.1. "accessories on request): device
that supplies electric current to the tool; its
specifications and regulations for use are
described in a specific manual.
M. Battery charger
request, paragraph
recharge the battery. Two battery charger
models are available: M1 (fast battery
charge); M2 (standard battery charge).
N. Battery backpack (attachment on request,
par. 15.3): device in which the batteries are
placed.
O. Connection cable: cable used to connect
the machine to the battery backpack.
P. Battery simulator (attachment on request,
par. 15.4): device that, if inserted in the
machine housing, allows the use of the
battery backpack.
4. ASSEMBLY
IMPORTANT The safety regulations to follow
are described in chap. 2. Strictly comply with these
instructions to avoid serious risks or hazards.
(accessory available upon
15.2): device used to
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling and
its packaging, always making use of suitable
equipment. Do not use the machine until all
the instructions provided in the "ASSEMBLY"
section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying attention
not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.
4.2 GRIP ASSEMBLY
4.2.1 Assembly of the front hand grip
1. Position the front handle (Fig.
3.A) on the rod (Fig. 3.B).
2. Assemble the leg guard (Fig. 3.C) on the
hand grip making sure it faces to the left.
3. Attach the handle to the leg guard with
screws (Fig. 3.D) and nuts (Fig. 3.E).
EN - 8