Stiga BC 500 Li 48 Manual De Instrucciones página 178

6.7.2 After use with battery
simulator (if available)
1. Move the battery backpack
selector to "OFF" (Fig. 11.B);
2. remove the battery simulator
from the machine (Fig. 22.P);
3. remove the battery backpack;
4. disconnect the connection cable
from the battery simulator (Fig.22.O)
and from the backpack (fig. 11.A)
5. remove the battery from the backpack
(Fig. 23) and charge it (par. 7.2.2);
6. allow the engine to cool before storing
the machine in an enclosed space;
7. Clean (para. 7.3);
8. Make sure there are no loose or
damaged components. If necessary,
replace the damaged components and
tighten any screws and loose bolts or
contact the authorised service centre.
IMPORTANT Always remove the battery (par
7.2.2) and fit the glade guard whenever you leave
the machine unused or unattended.
7. ROUTINE MAINTENANCE
7.1 GENERAL INFORMATION
IMPORTANT The safety regulations to follow
are described in chap. 2. Strictly comply with these
instructions to avoid serious risks or hazards.
Prior to carrying out any maintenance
operation, you need to:
• stop the machine;
• remove the battery from its housing and
recharge it (par 7.2.2);
• when the cutting means is stationary,
apply the blade protection cover, (except
when working directly on the blade);
• allow the engine to cool before storing in
an enclosed space;
• use suitable clothing, protective gloves
and goggles;
• read the relevant instructions.
– The frequency and types of maintenance
are summarised in the "Maintenance Table"
(chapter 13). The table will
your machine's safety and performance.
It summarises the main interventions to be
made and the frequency applicable to each
help you maintain
EN - 14
of them. Carry out the relevant task as soon
as it is scheduled to be performed.
– The use of
accessories could have negative effects
on machine operation and safety. The
manufacturer declines any responsibility for
damage or injury caused by said products.
– Genuine spare parts are supplied by
Authorised Assistance Centres and Dealers.
IMPORTANT Any
adjustment operations not described in this
manual must be carried out by your dealer or
Authorised Service Centre.
7.2 BATTERY
7.2.1 Battery power reserve
Battery power reserve (and therefore the cuttable
vegetation area before recharging is required)
mainly depends on:
a. Environmental factors, that cause higher
energy requirements:
– cutting, high, wet vegetation;
b. operator behaviour that should be avoided:
– switching the machine on and off frequently
whilst working;
– using a cutting means or cutting technique
that is unsuitable for the work to be
performed (par. 6.4);
– cutting speed unsuitable for the condition of
the grass to be cut.
To optimise battery power reserve it is always
recommended to:
• cut the grass when dry;
• set a cutting speed suitable for the condition
of the grass;
• use the most appropriate cutting means and
technique for the work to be performed.
If the need arises to use the machine for sessions
which exceed the capability of a standard battery,
it is possible to:
• purchase a second standard battery to
immediately replace the discharged battery,
without compromising
operations;
• purchase a battery with an extended power
reserve compared to the standard version
(para. 15.1).
7.2.2 Battery removal and recharging
1. Press the locking button located on the battery
on the machine (Fig. 22.A) or on the backpack
(Fig. 23. A) (if available);
non-original parts
maintenance
the continuity
and
and
of