Bus Coupler Overview - Aventics PROFINET VS series Instrucciones De Servicio

58 AVENTICS | PROFINET | R412023897–BDL–001–AA
Device Description
5.1

Bus coupler overview

6
7 8
Fig. 2: Bus coupler overview
1 Bus address label
2 LED display for diagnostic messages
3 BUS OUT X72, fieldbus connection for further PROFINET
modules
4 BUS IN X71, fieldbus connection for upstream PROFINET
modules
5 POWER X10 connection to supply power to the valve
solenoids
6 S4, sliding switch for selecting valve supply
7 S1, S2, rotary switches, not used
8 S3, DIP switch for setting modes
The bus coupler is only intended for use as a slave unit in a
PROFINET bus system.
The bus length can be up to 100 m between 2 participants
(without a repeater) depending on the transfer rate.
1 2
3 4 5
BUS IN
X71
BUS OUT
X72