Overview Of The Bus Coupler - Aventics DeviceNet Instrucciones De Servicio

60 AVENTICS | DeviceNet | R402003659–BAL–001–AG
Device description
DeviceNet address
Data rate
Diagnosis
5.1

Overview of the bus coupler

6
7 8
Fig. 2: Bus coupler overview
1 Bus coupler address label
2 LED display for diagnostic messages
3 BUS OUT X72 connection to control further bus couplers
4 BUS IN X71 connection to control the CL03/CL03-XL valves
5 POWER X10 connection to supply power to the valve solenoids
6 S4 sliding switch for selecting valve supply
7 S1, S2 rotary switches for assigning the station address
8 S3 DIP switch for setting modes
The bus coupler is designed only for use as a participant in a DeviceNet
field bus system.
The address of the bus coupler is set using the S1 and S2 rotary
switches.
The maximum data rate (baud rate) is 500 kbit/s and is set with the S3
DIP switch.
The supply voltages for the electronic circuitry and valve control are
monitored. If the valve supply voltages fall below a set limit, an error
signal will be generated and reported via the diagnostic LEDs and
diagnostic information.
1 2
3 4 5
BUS IN
X71
BUS OUT
X72