Setting The Data Rate; Assigning An Address To The Bus Coupler; Setting Diagnostic Messages - Aventics PROFINET VS series Instrucciones De Servicio

66 AVENTICS | PROFINET | R412023897–BDL–001–AA
Commissioning and Operation
S3
ON
↑
↓
OFF
S4
S3
S2
S1
Fig. 4: Removing/fitting the cover of the bus coupler
7.1.1

Setting the data rate

Data communication is fixed to a data rate of 100 Mbaud full
duplex.
7.1.2

Assigning an address to the bus coupler

The PROFINET address (PROFINET name) can only be set via
software tools (see section "Assigning names, IP addresses, and
subnet masks" on page 71).
7.1.3

Setting diagnostic messages

The device transmits all fieldbus-specific diagnostic messages.
All undervoltage or short circuit diagnostic messages are
transmitted to the input data field (see section "Test and
diagnosis" on page 73).
The tolerance range for the supply voltage is set via switches
S3.7 and S3.8.
1
2