Relief Function; Switching Mymodes With The Cockpit App - Ottobock Meridium 1B1 Instrucciones De Uso

8.2.12 Relief function

When weight is consistently placed on the heel without movement for more
than 2 seconds, the tip of the foot lowers to reach a more natural foot position.
In comparison to a prosthetic foot that cannot be adjusted automatically, this
results in a more even distribution of pressure between the residual limb and
the socket.
Possible applications include sitting with the heel in front of the knee axis,
standing while leaning against something, and standing on a downward slop­
ing surface.
8.3 MyModes
With the help of adjustment software, the prosthetist can activate and configure MyModes in addi­
tion to the basic mode. These can be selected by using the remote control or motion patterns.
Switching by using motion patterns has to be activated in the adjustment software by the prosthet­
ist.
The MyModes are intended for specific motion patterns or postures (e.g. inline skating, ...). Set­
tings can be adjusted using the Cockpit app or remote control (see Page 62).

8.3.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If
required, Bluetooth on the prosthesis can be switched on permanently afterwards (see
Page 62).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app or using the remote control, there are
no beep signals (see Page 60).
Once a connection to a prosthesis has been established, the cockpit app can be used to switch
between the MyModes.
Ottobock | 57