Signals For Operating States; Warnings/Error Signals - Ottobock Meridium 1B1 Instrucciones De Uso

13.2.1 Signals for operating states

Battery charger connected/disconnected
Beep signal
1x short
1x short
Mode switching
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app or using the remote control, there are
no beep signals (see Page 60).
Beep signal Vibration
signal
1x short 1x short
1x short 1x short
1x short 1x short
2x short 2x short
3x short 3x short

13.2.2 Warnings/error signals

Error during use
Beep signal
10x long
68 | Ottobock
Vibration signal
3x short
1x before beep signal Battery charger disconnected after start of char­
Additional action per­
formed
Mode switching using
remote control
Knocking with heel to switch
modes or
swing sideways 3 x to set
heel height
Weight placed on prosthetic
leg and leg kept still for 1
second to switch mode or
feet placed on same level
and weight distributed
evenly on both feet to set
heel height
Weight placed on prosthetic
leg and leg kept still for 1
second
Weight placed on prosthetic
leg and leg kept still for 1
second
Vibration signal
3x long
5x long
10x long
Event
Battery charger is connected or
battery charger already disconnected prior to
start of charging mode
Charging mode started (3 sec. after connection
of battery charger)
ging mode
Event
Mode switching performed using
remote control
Movement pattern recognised
Switching to basic mode (mode
1) carried out.
Switching to MyMode 1 (mode 2)
carried out.
Switching to MyMode 2 (mode 3)
carried out.
Event
Battery charge level under 25%
Battery charge level under 15%
Battery charge level at 0%: