Tightening Torque - TOHATSU BFT 60A Manual Del Propietário

3. Turn the hexagon part to
counterclockwise and separate the
strainer cup from the filter body.
4. Thoroughly clean the strainer cup
and fuel filter.
If the fuel filter is clogged, replace
it with a new one.
FILTER BODY
O-RINGS (Replace)
FUEL FILTER
PROJECTIONS
FLOAT (red ring)
STRAINER CUP
HEXAGON PART
5. Install the fuel filter, O-rings and
float.
Re-assemble the filter body and the
strainer cup using new O-rings.

TIGHTENING TORQUE:

3.0 N·m (0.3 kgf·m, 2.2 lbf·ft)
Align the center of the two fuel tubes and
the arrow of the suspension strap rib
6. Install the suspension strap to the
fuel filter assembly as shown
above.
7. Reinstall the fuel filter assembly
and suspension strap in the original
position.
8. Align the white paint on the fuel
tubes and the projections of the
filter body. Connect the fuel tubes
to the fuel filter assembly securely
with the clamps. Remove the tube
clip used to close the fuel tubes.
MAINTENANCE
Touch the suspension
strap to the lower face of
the filter body
123