Outboard Motor Installation - TOHATSU BFT 60A Manual Del Propietário

Outboard Motor Installation

STERN BRACKET
Ф22 WASHER (8)
Ф33 WASHER (4)
BOLT
(12×119 mm) (4)
1. Apply the silicone sealant (Three
Bond 1216 or equivalent) to the
outboard motor mounting holes.
2. Set the outboard motor on the boat
and secure with the bolts, washers,
and nuts.
Standard torque:
54 N·m (5.5 kgf·m, 40 lbf·ft)
The standard torque is given just as a
guideline. Torque of the nut can be
different according to the material of
the boat. Consult with an authorized
TOHATSU outboard motor dealer.
NUT (8)
INSTALLATION
ENGINE
HANGER
Install the outboard motor
securely. Loosely mounted
outboard motor can result in
accidental loss of the outboard
motor and damage and injury to
the equipment and personnel.
Before installing the outboard motor
on the boat, hang the outboard motor
with the hoist or equivalent devise by
attaching the two engine hangers to
the outboard.
Use the hoist which allowable load is
250 kg (551 lbs) or above.
47