Hofmann geodyna 8200 Manual De Operador página 138

8
A
8
8
8
138
5-92
5-93
5-94
5-94b
5-95
Operation
Figure 5-92 MINIMISATION "7", outside
 Rotate the wheel into marking position following the
arrows
 In this position make a double mark on the tyre
outer side exactly perpendicular to and above the
chuck.
 Confirm by pressing key 8.
The MINIMISATION "8" screen appears (Fig. 5-94).
Figure 5-93 MINIMISATION "7", inside
If the wheel cannotbe turned over on the rim (e.g.:
Asymmetrical and Directional),
press the menu key (A, Fig. 5-93), then

continue as shown on screen

MINIMISATION "7" outside (Fig. 5-92).
If the wheel can be turned over on the rim;
 Rotate the wheel into marking position following the
arrows
 In this position make a double mark on the tyre, on
the inside of the wheel, exactly above the chuck.
 Turn the tyre over on the rim (tyre changer).
 Confirm by pressing menu key 8.
The MINIMISATION "8" screen appears (Fig. 5-94b).
Figure 5-94b MINIMISATION "8"
 Push the tyre on the rim until the double mark
coincides with the valve (use tyre changer).
 Confirm by pressing menu key 8.
The MINIMISATION "9" screen appears (Fig. 5-95).