Hofmann geodyna 8200 Manual De Operador página 180

1
3
1
180
7-4
7-6
7-7
2
3
7-8
Setting Parameters
7.5 Counters
Every measuring run actually completed is stored.
Maximum count is 999,999 runs.
Once this number is reached, the counter is reset to
zero. The information is primarily useful for statistical
purposes, e.g. to obtain evidence of load intervals of
parts when defective, or of monthly (yearly) use of the
machine, etc. The measuring runs performed while
the machine is on are transferred into the permanent
memory and added when it is switched off. The counter
cannot be deleted or changed.
 In the SETTINGS screen (Figure 7-4), select the
"Counters" category (1, Fig. 7-6).
The data immediately available in the Values field are
the following:
a
List of Counters
a Total runs
b
completed
b With OK
c
completed with
result OK
c Optimisations = Total number of optimisations or
d
d Service runs = Total number of measuring runs in
e
e Since last
f
completed
calibration
f Clamps
7.6 Promotional text
 Select the "General Settings" Category in the
SETTINGS screen, then select one of the 5
"Promotional Text" Parameters in the central panel
(3, Fig. 7-7).
After the selection a keyboard is displayed with the
text entry field.
To switch to upper case and additional special
characters press key (1, Fig. 7-8).
To go back by one position in the text, press key (2,
Fig. 7-8).
To close and enter the current text string, press
"ENTER" (3, Fig. 7-8).
The promotional text, saved automatically, will appear
in the Main Screen INTRO SCREEN exactly as
entered by the user.
(Figure 7-6)
= Total number of measuring runs
= Total number of measuring runs
b a l a n c i n g
minimisations
Service mode
= Total number of measuring runs
since the last calibration.
= Total number of wheels clamped