Hofmann geodyna 8200 Manual De Operador página 40

40
4-18
4-19
4-20
4-21
Layout
The screen relating to the fault appears, showing initial
or basic information (Fig. 4-18).
Press the stop key (Fig. 4-19).
The second screen relating to the fault appears,
showing more detailed and second level information
(Fig. 4-20).
Press the stop key (Fig. 4-19) to quit the HELP page.
4.4 Electromechanical stop
Refer to Figure 4-21.
To perform an immediate stop:
• Press the Electromechanical stop button;
The electronic brake is activated to immediately stop
wheel shaft rotation, as well as any other balancer
(Lifter) automatic movement.
In the event of a stop due to an unexpected action by
the unit, reconstruct the steps taken:
Did the operator make an error or omit to do
something?
Correct the error and continue working. No special
procedure is required.
Did the unit do something unexpected?
• Read the relevant chapters again.
• Prepare the unit for a restart:
switch the unit off and on again.
• Carefully repeat the commands following the
indications in the operator's manual.
• If the unit does not function correctly,
WARNING: PREVENT ANY FURTHER USE OF THE
UNIT.
• Call the service team immediately.