Honda NT700V Manual Del Propietário página 273

Installation Notes:
• Reverse the removal procedure to install
the wheel.
• When installing the brake caliper
bracket, be carefull not to damage the
sensor and pulser ring (NT700VA).
• Before installing the rear wheel, check
that the wheel hub and final drive gear
splines are coated with grease.
• Be sure the splines on the wheel hub fit
into the final gear case.
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
E
If the caliper bracket cannot be inserted
between the swingarm and wheel collar,
align the holes in the swingarm and wheel
collar, then carefully drive it into position
with a plastic hammer.
• Tighten and torque the following nuts
and bolts:
Rear axle nut torque:
89 N·m (9.1 kgf·m, 66 Ibf·ft)
Rear axle holding bolt torque:
32 N·m (3.3 kgf·m, 24 Ibf·ft)
Rear brake stopper bolt torque:
89 N·m (9.1 kgf·m, 66 Ibf·ft)
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
113