JVC UX-G66 Manual De Instrucciones página 23

4
Press SET button to program the track number.
Track number
Here the track number 2 on the CD is stored into a
program number 1, and shortly after that the total
playback time of programed tracks appears in the display
window as follows:
5
Repeat steps 3 to 4 to program other tracks you
want up to 32 tracks.
• If you try to program a 33rd step
"MEMORY FULL" will appear in the display
window, and your entry is ignored.
• The total playback time of programed tracks
exceeds 99'59"
"– – : – –" will appear in the display window.
6
Press 6 (play/pause) button on the CD unit.
The programed tracks are played back in the order you
have set.
• Other CD operations are the same as Normal play.
7
Press 7 (stop) button to quit the Program play.
• When Program play finished, CD unit automatically
stops.
To check the program contents
Before playing back the CD, you can check the program
contents by using 4 / ¢ button.
Press ¢ button:
Shows the programed tracks in the programed
order.
Press 4 button:
Shows them in the reverse order.
To modify the program
Before playing back the CD, you can erase the last
programed track by pressing CANCEL button. Each time
you press the button, the last programed track is erased from
the end of program.
• To add new tracks to the program before you start
playing-back, simply select a track number again you
want to add (repeat steps 3 to 4).
Program number
Total playback time
To erase all the programed data
After playing back the CD, you can erase all the programed
track data by pressing 7 (stop) button. New program can be
entered again.
To exit from the Program play mode
Before or during playback, you can exit from Program play
mode as follows:
• Before playback, press PLAY MODE button twice.
• During playback, press 7 (stop) button then PLAY MODE
button twice.
Playback mode indicator goes off and the system resumes
Normal play mode.
Pressing 0 0 0 0 0 (open/close) button to open the CD
tray also quits and erases the program play.
Continued
18