Connecting Other Equipments - JVC UX-G66 Manual De Instrucciones

Continued

Connecting Other Equipments

You can connect the following equipments to the system:
• Audio equipment — used only as an analog playback
device.
• Audio equipment with an optical digital input terminal
— used as a digital recording device.
When you connect and use these equipments, refer also to
the manuals supplied with them.
To connect audio equipment without a digital
output terminal
Connect the audio output jacks on the other equipment and
the ANALOG IN jacks, using an audio cable (not supplied).
Be sure that the plugs of the audio cables and the jacks on
the rear panel of the unit are color coded: White plugs and
jacks are for left audio signals, and red ones for right audio
signals.
• DO NOT connect other equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
VOLTAGE SELECTOR
XT-UXG66
To audio output
on the other equipment
• By using audio cable (not supplied), connect
between the audio output jacks on the other
equipment and the ANALOG IN jacks.
9
To connect audio equipment with an optical digital
input terminal
By using both an optical digital cable (not supplied) and an
audio cable (not supplied), connect:
• Between the optical digital input terminal on the other
equipment and the optical digital output terminal on
XT-UXG66.
• Between the audio output jacks on the other equipment
and the ANALOG IN jacks.
(AC wall outlet)
To ANALOG IN
NOW, you can plug in the system and other connected
equipment FINALLY!
When connecting the AC power cord into a wall outlet, the
system switches to standby mode with STANDBY/ON lamp
lit red.
VOLTAGE SELECTOR
XT-UXG66
To optical digital input
To audio output
Protective Plug
Before connecting the other equipment,
remove the protective plug from the terminal.
DO NOT plug in before setting the voltage selector
switch on the rear of the unit and all connection
procedure are complete (check to see page 11).
(AC wall outlet)
To ANALOG IN
To DIGITAL OUT