Connecting Speakers - JVC UX-G66 Manual De Instrucciones

AM antenna
ANTENNA
AM
EXT
FM 75
COAXIAL
AM loop antenna (supplied)
1
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
2
Turn the AM loop antenna until you have the best
reception.
To connect an external AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
(The AM loop antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch
any other terminals and connecting cables.
• Keep the antennas away from metallic parts of
the units, connecting cables, and the AC power
cord.
Vinyl-covered wire
(not supplied)
AM
LOOP

Connecting Speakers

You can connect the speakers using the speaker cords.
1
Speaker Cord
RIGHT LEFT
Black
Right speaker
1
Open the speaker terminal.
2
Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+)
to red (+) and black (–) to black (–).
3
Close the speaker terminal on the rear of the unit.
When connecting speaker cords
• Make sure to connect the cords correctly following
the right series of above steps.
During operation, wrong connection or a short
circuit make the power turned off to protect the
system.
The clock loses the setting and is reset to "0:00".
Also the MD recording may fail.
• Use only speakers with the same speaker
impedance as indicated by the speaker terminals
on the rear of the unit.
Continued
2, 3
Red
Speaker Cord
SPEAKERS
Left speaker
8