Searching And Skipping Tracks; Programing The Playing Order Of The Tracks - Program Play - JVC UX-G66 Manual De Instrucciones

Continued
4
Press 6 (play/pause) button on the CD unit.
Each track of the CD starts playing one after another,
and stops when the final track has finished playing.
• To stop playing back for a moment, press 6
(play/pause) button on the CD unit.
The playback time starts blinking in the display
window.
• To resume playback, press 6 (play/pause)
button again.
Playback continues from the point where it was
stopped for a while.
5
Press 7 (stop) button to stop playing back the CD.
Following information for the CD appears in the display
window.
Total track number
6
Press 0 (open/close) button on the CD unit to
remove the CD.
• Pressing 0 (open/close) button during playback
directly, the CD unit stops playback and opens CD
tray.

Searching and Skipping Tracks

While playing back a CD, you can do the following
operations.
To search and skip to a particular point in a track
During playback, press and hold 4 / ¢ button to meet
the desired passages in a track:
Press and hold or ¢ button:
Fast forwards in the track.
Press and hold or 4 button:
Fast reverses in the track.
UP/DOWN button on the remote control is also
available to searching operations.
17
Total playback time
To go to another track
Before or during playback, press 4 / ¢ button
repeatedly:
Press ¢ button:
Skips to the beginning of the next and succeeding
tracks.
Press 4 button:
Goes back to the beginning of the current and
previous tracks.
Rotating MULTI JOG dial clockwise also changes the tracks
forwards quickly, while rotating it counterclockwise the
tracks reverses quickly.
< / > button on the remote control is also available
to skipping operations.
Programing the Playing Order of the Tracks
— Program Play
You can arrange the order in which the tracks play before
you start playback. You can program up to 32 tracks.
1
Place a CD.
• If the current playing source is not the CD, press
6 (play/pause) button on the CD unit, then
7 (stop) button before going to the next step.
2
Press PLAY MODE button repeatedly until "CD
PROGRAM" appears in the display window.
• Each time you press the button, playback mode
indicators also change as follows:
PROGRAM
Canceled
(Normal play)
3
Rotate MULTI JOG dial to select a track number to
be programed (< / > buttons also available).
Track number
RANDOM
Program number