Dräger SilverLine Instrucciones De Uso página 39

Replacing the compressed gas cylinder
WARNING
Risk of damage to the device and of user injury
When the pressure reducer is removed while
still under pressure, pressure bursts may cause
injury to the user or damage seals.
After using the pressure reducer, first close the
valve of the compressed gas cylinder with mod-
erate force and then release the remaining pres-
sure completely. Only disconnect the device
from the pressure reducer after releasing all
pressure from the system.
1 Close the valve of the compressed gas cylinder.
2 Use up or vent the gas remaining in the pressure
reducer completely until the pressure gauge
reads 0.
3 Disconnect pressure reducer from the com-
pressed gas cylinder.
4 Replace the compressed gas cylinder.
Storing the pressure reducer
After ending operation:
 Disconnect the hose from the outlet port of the
pressure reducer. For permanent hose connec-
tions, disconnect the hose from the the device
port.
 Store the pressure reducer in a dust-free and dry
environment.
Instructions for use SilverLine
Fault – Cause – Remedy
Fault Cause
Connection be- The sealing
tween cylinder ring is dam-
and pressure aged
reducer is not
tight
The output The valve seat
pressure rises; is soiled or
the relief valve damaged
opens
Leakage in the The diaphragm
housing area is defective
Decreasing Cylinder is
flow or no flow empty or
closed
Reprocessing
Remedy
Safety information
Replacement of
the sealing ring
WARNING
by service per-
Risk due to inappropriately reprocessed prod-
sonnel
ucts
Reusable products must be reprocessed, other-
Repair by spe- wise there is an increased risk of infection.
– Follow the infection prevention policies and
cialized service
reprocessing regulations of the health-care
personnel
facility.
– Follow the national infection prevention pol-
Repair by spe-
icies and reprocessing regulations.
cialized service
– Use validated procedures for reprocessing.
personnel
– Reprocess reusable products before first
Replace the
use and after every use.
cylinder or
– Observe the manufacturer's instructions for
open it
cleaning agents, disinfectants, and repro-
cessing devices.
CAUTION
Risk due to faulty products
Signs of wear, e.g., cracks, deformation, discolor-
ation, or peeling, may occur with reprocessed prod-
ucts.
Check the products for signs of wear and replace
them if necessary.
Information on reprocessing
Follow the national infection prevention policies and
reprocessing regulations.
Follow the infection prevention policies and repro-
cessing regulations of the health-care facility (e.g.,
concerning the reprocessing cycles).
English US
39