Finishing The Functional Cosmesis - Ottobock 3F1-1 Instrucciones De Uso

Ocultar thumbs Ver también para 3F1-1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 70
18
19

6.8 Finishing the functional cosmesis

Complete the following steps to finish the functional cosmesis:
1) Assemble the functional shank, knee joint and prosthetic foot.
20
INFORMATION
The inductive charger can be used with the 3F1=2 functional cosmesis Genium after putting on
the functional stocking. Exposing the charging unit is not necessary.
Putting on the functional stocking
Complete the following steps to put on the functional stocking:
36
2) Secure the sheath on the inside of the
opening with contact adhesive.
3) Press the installation ring for the inductive
charger (4X259) into the opening so it is
flush with the foam and sheath.
INFORMATION:
647G1148 instructions for use.
4) Assemble the charging unit flush on the
outside of the foam.
INFORMATION:
647G1148 instructions for use.
2) Pull the functional stocking over the
assembly.
INFORMATION: The functional stocking
should extend 1 cm beyond the foot
cosmesis.
Please
note
the
Please
note
the

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3f1-2

Tabla de contenido