Preparation For Use; Required Tools; Preparation Of The Functional Knee Part - Ottobock 3F1-1 Instrucciones De Uso

6 Preparation for use

6.1 Required tools

• Adhesive tape
• 636N9 contact adhesive
• Measurement equipment: folding rule
• Scissors
• Scriber
• 4X258 installation tool for inductive charger
• 710D4 torque wrench (up to 30 Nm)
• Allen key size 2
• Allen key size 4
• Double-sided adhesive tape
• Protective goggles
• Dust mask
• Pedilen or Plastazote (thickness 5 mm)

6.2 Preparation of the functional knee part

Complete the following steps to put on the functional knee part:
1
2
1) Slightly expand the functional knee part
and pull it over the frame of the joint.
2) Secure the position of the upper knee part
with the Allen key size 2.
29