Invacare Scorpius-A Folleto De Instrucciones página 12

Scorpius-A
Power Switch:
• Press the button to turn on/off the power
• Power standby (locked) - red light
• Power on (unlocked) - green light
• Power off - light off
Auto-power off:
Power will automatically be off in 30 seconds if no
activity is detected during power standby period
(locked, red light) to prevent tap error.
Digitally Unlock Your Scooter:
Press the power switch. The power (red light) will be on
•
standby for you to unlock.
• To unlock, enter your password on the number pad (D).
Light indicator (C) will light up each time the number is
entered. Press (E) on the pad when password entering is
finished. (Figure 7)
• The power light will turn green when the scooter is
successfully unlocked.
Factory Default Password: 1234
If there is a type error, press the (E) key or power switch button again to re-enter the password.
Password Setting:
• Once scooter is unlocked (power green light on), press and hold the (E) key for 3 seconds. The pad light
will be flashing three times.
• Enter your password on number pad (D). The password can be a 1-4 digits number. Digits can be
repeated. Light indicator (C) will light up each time the number is entered.
• Press (E) on the pad when password entering is finished. Pad light will be flashing three times.
If there is a type error, press the power switch button again or wait for 30 seconds to re-enter the
password. Scooter must be unlocked before you can reset the password. If you forget the password,
please unlock the scooter by RF remote control.
RF Sensor Unlock Your Scooter:
• Press the power switch. The power (red light) will be on
standby for you to unlock.
• To unlock, place the RF remote to the panel (spot near
power switch for best reading result). (Figure 8)
• The power light will turn green when the scooter is
successfully unlocked.
• The sensor transmit is up to 20 mm. However, please keep the distance between RF sensor and
panel as close as possible.
• Do not dissemble the RF remote. The inner sensor chip may be damaged.
• Do not turn off the power while unlocking the scooter, no matter whether it is digital unlock or RF
sensor unlock. The user will need to turn the power back on and re-unlock again if unlocking is
interrupted.
• The scooter cannot be operated unless it is unlocked (green light on).
1656610~B
Figure 6
Figure 7
Figure 8
Instruction Booklet
(C)
(D)
(E)
12