Invacare Scorpius-A Folleto De Instrucciones página 13

Scorpius-A
Panel Backlight Adjustment (Five Levels):
• Press the power switch to get the scooter on power
standby (red light on), then press and hold both
acceleration [ ] / deceleration [
2 seconds. The panel light will be all on when scooter is
ready for backlight setting. (Figure 9)
• Press [ ] to increase level of backlight. Press [
decrease level of backlight.
• Press the power switch to save the backlight setting.
• Panel backlight can be adjusted under power standby
mode (red light), user does not have to unlock the scooter.
Battery / Error Light Indicator:
The light will be showing the battery status or errors of scooter.
If scooter has errors, the light indicator will be flashing (see
section 8). This light indicator is also the indication of battery
status (see section 6-3). (Figure 10)
Speed Adjustment:
• Press acceleration [
increase / decrease speed.
• There are 3 different speeds of adjustment fastest 3>2>1
slowest. (Figure 11)
• Do not set the speed at maximum when
operating the scooter.
• Adjust the speed at maximum when inclining a
slope, and adjust to minimum speed when
declining.
Head-Light / Tail-Light:
• Press button [
tail-light. The [
• Switch off by pressing the button again. The [
will be off on the panel. (Figure 12)
Tail-light will be on anyway when the brake is
engaged and when the scooter speed is reduced.
Horn:
• Press horn button to sound the buzzer. Buzzer sound and
light will last until you release the horn button. (Figure 13)
1656610~B
] buttons for
] / deceleration [
] once to switch on the head-light and
] will be lighted on the panel.
] to
Figure 9
Figure 10
] button to
Figure 11
] light
Figure 12
Figure 13
Instruction Booklet
(1) (2) (3)
13