Local Legal Information - Ottobock Meridium 1B1 Instrucciones De Uso

Ocultar thumbs Ver también para Meridium 1B1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 145
12 Legal Information
All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
12.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.
12.2 Trademarks
All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
12.3 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices.
This product has been classified as a class I device according to the classification criteria out­
lined in Annex IX of the directive. The declaration of conformity was therefore created by the man­
ufacturer with sole responsibility according to Annex VII of the directive.
This product meets the requirements of the European Directive 1999/5/EC for radio equipment
and telecommunications terminal equipment. The conformity assessment was drawn up by the
manufacturer in accordance with Annex III of the directive.

12.4 Local Legal Information

Legal information that applies exclusively to specific countries is written in the official language
of the respective country of use in this chapter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter­
ference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/ TV technician for help.
Ottobock | 63

Publicidad

Tabla de contenido
loading

Tabla de contenido