Sony VideoStore VSR-1000 Instrucciones De Funcionamiento página 13

3 2-channel analog audio/video output
section (provided by an optional BKSR-102
Two-Channel Decoder Board)
The following illustration assumes that three BKSR-
102 boards are installed.
CHANNEL A
CH1
1
CH2
AUDIO OUT
VIDEO
SYNC
IN
1
2
COMPOSITE OUT
CH1
CH2
AUDIO OUT
VIDEO
SYNC
IN
2
1
2
COMPOSITE OUT
CHANNEL B
BKSR-102
1 CHANNEL A and B analog audio output
connectors (XLR 3-pin, male)
Output 2-channel analog audio signal decoded from
MPEG data.
CH1: Audio channel 1 signal
CH2: Audio channel 2 signal
2 CHANNEL A and B sync signal input
connectors (BNC type) and analog composite video
output connectors (BNC type)
SYNC IN: Input a reference sync signal (composite
video signal or black burst signal).
COMPOSITE 1 and 2: Output analog composite
video signal decoded from MPEG-2 data. The
same signal is output from the two connectors.
When the above-mentioned SYNC IN connector
receives a sync signal input, a video signal is
output in synchronization with that signal. With
no sync signal input to SYNC IN, the video signal
is output in synchronization with the signal input
to the REF VIDEO IN connector described on the
previous page.
CHANNEL A CHANNEL A
CH1 CH1
CH2 CH2
AUDIO OUT AUDIO OUT
VIDEO VIDEO OUT
SYNC
Y
IN
3
1 R-Y
2 B-Y
COMPOSITE OUT COMPONENT
CH1 CH1
CH2 CH2
AUDIO OUT AUDIO OUT
VIDEO VIDEO OUT
SYNC
Y
IN
1 R-Y
2 B-Y
COMPOSITE OUT COMPONENT
CHANNEL B CHANNEL B
BKSR-102 BKSR-102
With the BKSR-102 Two-Channel Decoder Board's
composite/component switch set to component, a
component signal (Y, R–Y, B–Y) can be output.
For more details, see the description of "3 CHANNEL A
and B analog component video output connectors."
3 CHANNEL A and B analog component video
output connectors (BNC type)
With the BKSR-102 Two-Channel Decoder Board's
composite/component switch set to component, these
connectors output analog component signals (Y, R–Y,
B–Y) obtained from MPEG-2 video data decoding.
Note
The connector identification label for component video
output connectors (see the left figure) comes with the
BKSR-102 board.
4 1-channel analog audio/video output
section (provided by an optional BKSR-101/
101P One-Channel Decoder Board)
The following illustration assumes that three BKSR-
101/101P boards are installed.
AUDIO OUT AUDIO OUT
CH1
CH2
CH3
CH4
VIDEO
REF IN
OUT
COMPOSITE
COMPONENT COMPONENT
Y 1 Y
2
R-Y R-Y
3
B-Y B-Y
BKSR-101 BKSR-101
(BKSR-101P) (BKSR-101P)
AUDIO OUT
CH1 CH1
CH2 CH2
1
CH3 CH3
CH4 CH4
VIDEO VIDEO
REF IN REF IN
2
OUT OUT
COMPOSITE COMPOSITE
COMPONENT
3
1 Y 1
2 2
R-Y
3 3
B-Y
BKSR-101
(BKSR-101P)
13