Changing The Assembly Location - Nussbaum SPRINTER MOBIL 2500 Instrucciones De Servicio

5 Oil filling opening
• Fill new hydraulic oil (e.g. HLP 32). About 8 litres are needed.
• Provide an on-site electrical connection of 3 ~/N + PE, 400 V, 50 Hz, fuses
with 16 A, slow.
• Connect the electric cable to the customer-provided mains breaker
(e.g. a Cekon plug).
• Turn on main switch (2) and press the „LIFT" button (3).
!
If the lift does not move upwards after a few seconds, the direction of
rotation of the motor is incorrect. Swap 2 phases on the plug.
• Then press the „LIFT" button (3) again and raise and lower the lift to its
limit positions several times without load. This will largely ventilate the hy-
draulic system.
4.3

Changing the assembly location

• To operate the lift, it must be raised about 500 mm so that the back
wheel axes (9) and guide roller (6) can be engaged.
8
7
6 Guide roller
7 Torsion shaft
20110005 SPRINTER MOBIL 2500-3000 - HYMAX PRO 2500-3000 OPI
9
6
illustration similar 004
8 Towing bar 9 Wheel axles
Version 1.0
• Place the guide rollers (6) over the torsion shafts (7). Then push them until
the tappet (10) is located in the notch (11) of the guide roller.
5
026
6 Guide roller
10 Tappet
• The wheel axles (9) are in the lower plate of the lift (12).
003
9
9 Wheel axle
12 Wheel axle storage
i
To simplify mounting, it may be necessary to raise or lower the lift a
little.
Then lower the lift completely. Hang the tow bar (8) into the guide roller (6)
and the lift can then be moved.
To remove the roller, follow the instructions in the reverse order.
The mobile hand unit quickly makes the SPRINTER MOBIL - HYMAX PRO rea-
dy to use again.
To change the setup location of an anchored lift, the conditions accor-
ding to the setup guidelines in Section 4.1 must be ensured.
!
Use new anchors. The old anchors are no longer fit for purpose!
11
10
11 Notch 19 Guide roller holder
19
6
005
12
019
29