System Master Sheet; Manufacturer; Purpose; Changes To The Design / Construction - Nussbaum SPRINTER MOBIL 2500 Instrucciones De Servicio

9

System master sheet

9.1

Manufacturer

Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
9.2

Purpose

The SPRINTER MOBIL - HYMAX PRO lift is a lifting accessory for the lifting of
vehicles up to a total weight of 2,500 kg or 3,000 kg, in normal workshop
operation at a maximum load distribution of 3:2 in or against the drive-in
direction.
Additionally, there is a distinction between cars operated with front or rear
drive.
The lift is not set up for standing on the receiving plate or for personnel
conveyance.
The lift can be used flexibly. Any solid, even surface can be used as a setup
location. However, it can also be fastened to the floor.
The set up of the standard lift is not permitted in explosion endangered
work shops.
After construction and significant maintenance changes on load carrying
parts the lifting table must be inspected afterwards by a specialist who ap-
proves the changes.
Operation of the lift is done by an operating unit that is located immedia-
tely next to the lift.
9.3

Changes to the design / construction

Inspections by a technical expert are required before recommissioning
(date, type of change, technical expert signature).
...................................................................................................................................
...................................................................................................................................
...................................................................................................................................
Name, address of technical expert
...................................................................................................................................
Location, date
...................................................................................................................................
Technical expert signature
9.4

Changing the assembly location

Inspections by a technical expert are required before recommissioning
(date, type of change, specialist signature).
...................................................................................................................................
...................................................................................................................................
...................................................................................................................................
Name, address of technical expert
...................................................................................................................................
Location, date
...................................................................................................................................
Technical expert signature
20110005 SPRINTER MOBIL 2500-3000 - HYMAX PRO 2500-3000 OPI Version 1.0
35