System Connections Of Input/Output Power Cables - Eaton Pulsar Serie Manual De Instalación Y De Usuario

2.9

System Connections of Input/Output Power Cables

This type of connection must be carried out by qualified electrical personnel.
Before making any connections, check that the upstream protection device (Normal AC source) is open "0" (OFF).
To access the connection terminal blocks, see Section 1.2, Rear Panel:
Input Connection
Always connect the ground cable first.
1
2
knockouts
1. Remove the terminal block cover (2 screws).
2. Remove the 2 screws as shown in step 2 and
knockout for input and output.
86-87021-00 A01 - Page 21