Assembly; Assembling The Cl03/Cl03-Xl With Profibus Dp - Aventics PROFIBUS DP Instrucciones De Servicio

PROFIBUS address
Data rate
Diagnosis
Number of
valves controlled
AVENTICS | PROFIBUS DP | R402003657–BAL–001–AG
(slaves) per segment are connectable. With repeaters, this can
be expanded to up to 127 bus participants (slaves).
The address of the bus coupler is set using the S1 and S2 rotary
switches.
The bus coupler is automatically set to the master bus speed
between 9.6 kbps and 12 Mbps.
The supply voltages for the electronics circuitry and valve
control are monitored. If they exceed or fall below a set limit, an
error signal will be generated and confirmed with the diagnostic
LEDs on the bus coupler and with diagnostic messages.
Up to 32 solenoids, in any suitable combination of double
solenoid and single solenoid valves, can be connected.
6

Assembly

6.1 Assembling the CL03/CL03-XL with
PROFIBUS DP
Risk of damage to the unit
There is a risk of damage to the bus coupler if its cover is
exposed to shocks and blows.
O
See to that the bus coupler is not exposed to blows.
O
Transport the unit well packaged.
You will receive your individually configured CL03/CL03-XL
series valve system completely fitted with all components:
W
Bus coupler
W
Valve system
W
End plate
The operating instructions accompanying the CL03/CL03-XL VS
describe in full how to assemble the entire valve system. The VS
may be mounted in any orientation. However, mounting the VS
NOTICE
63
Assembly