Commissioning And Operation; Making Settings - Aventics PROFIBUS DP Instrucciones De Servicio

70 AVENTICS | PROFIBUS DP | R402003657–BAL–001–AG

Commissioning and operation

7 Commissioning and operation
7.1

Making settings

The following settings have to be made:
W
Setting the data rate
W
Assigning an address to the bus coupler
W
Setting diagnostic messages
W
Selecting the valve supply
All of these settings are made with the switches beneath the
cover of the bus coupler. See Fig. 4 below for position of
switches.
Proceed as follows to make the settings:
1. Remove the cover of the bus coupler by undoing the four
screws (1).
2. Make the settings with the switches as described below.
3. Refit the cover carefully according to Fig. 4 below. Ensure
that the sealing (2) is positioned correctly. Tighten the
screws (1) with a torque of 1.0 to 1.2 Nm.