Machine Assembly; Bar And Chain Mounting - Hornbach CJ 300 Manual De Instrucciones

MACHINE ASSEMBLY

4. MACHINE ASSEMBLY
IMPORTANT
The machine is supplied with
the bar and chain dismantled and the oil and fuel
tanks empty.
WARNING!
ing the assembly should be done on a flat and
stable surface, with enough space for ma­
chi ne handling and its packaging, always
making use of suitable equipment.
Disposal of the packaging should be done in
ac cordance with the local regulations in force.
WARNING!
gloves when handling the bar and chain.
Mount the bar and chain very carefully so as
not to impair the safety and efficiency of the
machine. If in doubt, contact your dealer.
Before fitting the bar, make sure the chain brake is
not engaged; this is done by pulling the front hand
guard right back towards the body of the machine.
WARNING!
with the engine off.
1. SPIKED BUMPER ASSEMBLY
(if not already factory assembled)
– U nscrew the nut (1) and remove the clutch co-
ver (2).
– S ecure the spiked bumper (3) to the machine
frame using the two supplied screws (4) (Fig. 1).

2. BAR AND CHAIN MOUNTING

– Unscrew the nut and remove the clutch cover to
access the drive sprocket and the point where
the bar is to be fitted (Fig. 2).
– R emove the plastic spacer, (1); this spacer must
be used exclusively when transporting the ma-
chine in its packaging and must not be used at
any other time (Fig. 2).
– A ssemble the bar (2) by inserting the stud bolt in
the groove and push it towards the back of the
machine body (Fig. 3).
Unpacking and complet­
Always wear heavy­duty
Perform all operations
– Mount the chain in the right direction around the
drive sprocket and along the bar rail (Fig. 4). If
the tip of the bar has a nose sprocket, make sure
the drive links fit correctly in the sprocket rims.
– Remove the cover without tightening the nut,
making sure to insert the two rear fasteners in
their respective slots properly.
– C heck that the chain tension adjuster pin (3) of
the clutch cover is fitted properly in the hole on
the bar; if it isn't, turn the chain tension ad j u s ter
screw (5) using a screwdriver until the pin is
completely inserted (Fig. 5).
– T urn the chain tension adjuster screw (4) to ad-
just the chain tension (Fig. 5).
– L ifting the bar, tighten the cover nut securely
using the supplied wrench (Fig. 6).
• Checking the chain tension
Check the chain tension. The tension is correct
when the drive links do not slip out of the chain
guides if you hold the chain in the middle of the
bar (Fig. 7).
33
EN