Index Of Parameters - Roger Technology CTRL Instrucciones Y Advertencias Para El Instalador

12

Index of parameters

FACTORY
PARAM.
DEFAULT
Enable RS485 serial communication (MASTER-SLAVE)
Barrier model and the length of the boom selection
Automatic closing after time pause (from barrier completely open position)
Automatic closing after mains power outage
Step mode control function selection (PP)
Pre-manoeuvre flashing warning
Condominium function for partial open command (PED)
Enable "operator present" function
Barrier open/photocell test function and battery saving mode indicator lamp
Enable the B73/EXP signal device to indicate barrier completely open/closed
positions
Setting deceleration during opening
Setting deceleration during closure
"BreakAway" ACS/BA/60 detachable boom coupling system enabling
SC output operating mode
Setting automatic closing time
Enabling of management for opening with automatic re-closure exclusion
Enable electric lock
Obstacle detection time setting (crush prevention)
Setting opening start acceleration
Setting closure start acceleration
Opening speed setting
Closure speed setting
Approach speed setting
Opening approach distance setting
Closing approach distance setting
Number of automatic closure attempts after activation of sensing edge or
obstacle detection (crush protection)
Photocell mode for barrier opening (FT)
Photocell mode for barrier closure (FT)
Photocell (FT) mode with barrier closed
Enable close command 6 s after activation of photocell (FT)
Motor stop distance setting
Installation position of barrier relative to gateway (seen from the inspection hatch
side).
Sensing edge COS configuration
Radio channel 1 configuration (PR1)
Radio channel 2 configuration (PR2)
Flashing light / upper cover lights frequency configuration
DESCRIPTION PAGE
75
75
75
75
76
76
76
76
76
76
77
77
77
77
77
77
77
78
78
78
78
78
78
78
78
78
78
78
79
79
79
79
79
79
79
79
73