3.6. Final installation
You have successfully completed all your installation tests. You can now carry out the final installation
of your immersion detector.
1 Bring your immersion detector to "complete stop" mode (see item 4.6) so that it can be
1
handled freely during its final installation.
2
Remove the weight from the cover.
4
Remove the cover.
6
Remove the 4 pieces of stabilizing foam.
8
Mark the 4 holes to be drilled.
3
Unscrew the 4 screws.
5
Remove the device and the booster from
the coping.
7
Reposition the device on the
coping.
9
Mark the water level on the tube of your
device.
11
5 mm mini