Replacing The Batteries; Frequently Asked Questions - Astralpool 37059 Manual De Instalación

4.7. Replacing the batteries

Your immersion detector gives a low-battery alert by:
1 short, low-pitched beep every minute,
I
I 4 short, low-pitched beeps every time the magnet is moved over the swimmer symbol.
In this case, the 7V lithium battery must imperatively be replaced as soon as possible with a new
battery, available from your retailer.
Once the battery has been replaced, put the cover back on, screw the 4 screws and replace
the 4 plugs on the cover.
You must imperatively perform the validation tests described in item 3.7.
Be responsible, and take the old batteries back to your retailer instead of throwing them away.
We advise you not to change the batteries at the start of the season.
4.8. I have a problem with my immersion detector
Please contact by phone or mail the AstralPool After-Sales Service:
I Tel: +34.93.713.63.44.
Address:
I
Please provide a clear description of the problem encountered, so that your device can be processed
quickly. Please also provide our technicians with your details and a sketch of your pool, including its
dimensions (length, width, depth, recess if any) as well as the location of the return fittings, vacuum
fittings, skimmer, and any other piece of equipment which might create disturbances, such as, for
instance, a swim jet. Show the location of your immersion detector on the edge of your pool.
This information will help our technicians to better understand the problem with your device, and
to quickly find a solution.

5. Frequently asked questions

During the installation
QI1. During the test phase with filtering or filtering + robot cleaner, the siren goes off accidentally, or
your immersion detector switches from monitoring mode to non-monitoring mode (red light flashing)?
I RI1.1. Make sure that your immersion detector is not within one meter of the filtration system (return
fittings, waste plug, skimmer, vacuum fittings, etc.) or waterfall or any other device that may disturb the
pool at this place.
I
RI1.2. Check the immersion depth of your immersion detector. Rectify it if required.
I RI1.3. Perform the installation and validation tests under favorable weather conditions.
I RI1.4. Your immersion detector is not suited to your type of pool. Ask your retailer or the after-sales
service for advice at +34.93.713.63.44.
AstralPool SAU
Avda Francesc Macia, 38 Planta 18
08208 Sabadell – Spain
21