Choice Of Location - Astralpool 37059 Manual De Instalación

3
LITHIUM
BATTERY
Connect the lithium battery to the PCB.
Validation sound signal (1 long beep followed
by 10 short beeps). Your device is in inactive
monitoring (red flashes from the indicator
light at the rear of the device).
Sun and Confort
TM TM
You must on no account change the settings of these switches. Be sure to check the settings
of these switches (ON or OFF), the combination must be as follows:
ON
OFF

3.3. Choice of location

Your fall detector must be positioned in the center of the greatest length of your swimming
pool, on a coping (position recommended for rectangular swimming pools). If your pool does not
correspond to the configurations shown below, ask your retailer for advice.
Ensure that the central unit is more than one meter away from the filtration system
(return fittings, waste plug, skimmer, vacuum fittings, etc.) or waterfall or any other
device that may disturb the pool at this place.
Your immersion detector is designed and configured in compliance with standard
NF P90-307/A1, and can be used on pools with maximum dimensions of 10 x 5 meters.
Your immersion detector must not be more than 7 meters away from all possible fall
locations.
For a larger swimming pool, several immersion detectors must be installed. Contact your
retailer for advice.
In the case of a pool of a particular shape, contact your retailer for advice.
have a system which comes in the form of several small parallel switches.
6
4
Put the cover back in place without tightening
the screws.
1 on ON
2 on OFF
3 on ON
4 on ON
5 on ON