Astralpool 37059 Manual De Instalación página 13

10
Remove the device. Make sure you handle
your device carefully.
11
Recorded water
level
15 cm
±
(
12
Remove the wedge plug, and for Confort
remove the pH probe from its housing,
behind the rigid tube.
14
Carefully remove the rigid tube.
DO NOT REMOVE THE BLACK TUBE.
Correct installation
Using the measuring tape, measure the immersion
depth from the water level. This must be between
12 cm and 18 cm (ideally 15cm). If the immersion depth
is not right, mark out the recommended depth
of 15 cm (+/- 3cm) using a pencil and measuring tape.
Example:
3cm) Immersion depth recorded = 25 cm.
Recommended depth = 15 cm ± 3 cm.
You must carefully cut your probe down to size by:
25 - 15 = 10 cm from the bottom of the tube.
13
,
TM Unscrew the 2 screws holding the rigid
tube.
15
Firmly hold the rigid tube while cutting with
the hacksaw.
12
Incorrect installation