Mettler Toledo IND780 Guia De Instalacion página 46

Figure 2-22: IDNet Protective Bracket
To install the protective bracket, remove the nut that secures the IDNet connector and PCB to the
enclosure, slide the bracket over the connector, and position it as shown in Figure 2-22. Reinstall
the nut to secure the bracket, connector and PCB, and torque the nut to 8 Nm (70 lbf-in).
2.9.3.2.2. Ethernet Cabling
For Ethernet connections, route an open end Ethernet cable without the RJ-45 connector through the
16mm ATEX plastic cable gland (see Table 2-1) and into the IND780 harsh enclosure. Use
appropriate crimping tools to strip, crimp and attach the RJ-45 connector to the end of the Ethernet
cable.
2-26 METTLER TOLEDO IND780 Division 2 and Zone 2/22 Installation Guide 64063214 | 07 | 02/2018