Mettler Toledo IND780 Guia De Instalacion página 8

IN ORDER TO INSTALL THE DIVISION 2 APPROVED IND780 TERMINAL UTILIZING THE U.S.
OR CANADIAN UL APPROVAL, METTLER TOLEDO CONTROL DRAWING 64069877 MUST BE
FOLLOWED WITHOUT EXCEPTION. IN ORDER TO INSTALL THE CATEGORY 3 MARKED IND780
TERMINAL UTILIZING THE EUROPEAN ATEX APPROVAL, THE TYPE EXAMINATION
CERTIFICATE DEMKO 07ATEX0520819X AND ALL LOCAL REGULATIONS MUST BE
FOLLOWED WITHOUT EXCEPTION. IN ORDER TO INSTALL THE IND780 TERMINAL UTILIZING
THE IECEx APPROVAL, THE CERTIFICATE OF CONFORMITY IECEx UL 10.0014X AND ALL
LOCAL REGULATIONS MUST BE FOLLOWED WITHOUT EXCEPTION. FAILURE TO DO SO
COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
THE IND780 TERMINAL MUST BE INSTALLED AND MAINTAINED PER THE SPECIAL
CONDITIONS LISTED IN CHAPTERS 2 AND 3 OF THIS MANUAL WITHOUT EXCEPTION.
FAILURE TO DO SO COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
IF THE KEYBOARD, DISPLAY LENS OR ENCLOSURE IS DAMAGED ON A DIVISION 2 OR ZONE
2/22 MARKED IND780 TERMINAL THAT IS USED IN A DIVISION 2 OR ZONE 2/22 AREA, THE
DEFECTIVE COMPONENT MUST BE REPAIRED IMMEDIATELY. REMOVE AC POWER
IMMEDIATELY AND DO NOT REAPPLY AC POWER UNTIL THE DISPLAY LENS, KEYBOARD OR
ENCLOSURE HAS BEEN REPAIRED OR REPLACED BY QUALIFIED SERVICE PERSONNEL.
FAILURE TO DO SO COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
THE INTERNAL #64064718 PDX
AN IND780 TERMINAL INSTALLED IN AN AREA CLASSIFIED AS CL I GP A,B DIVISION 2 OR
CL I ZONE 2 GP IIC IN THE UNITED STATES and CANADA. FAILURE TO COMPLY WITH THIS
WARNING COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
THE INTERNAL #22009911 DISCRETE I/O RELAY OPTION (KIT NUMBER 64057419) MUST
NOT BE USED IN AN IND780 TERMINAL INSTALLED IN AN AREA CLASSIFIED AS DIVISION 2
OR ZONE 2/22. FAILURE TO COMPLY WITH THIS WARNING COULD RESULT IN BODILY HARM
AND/OR PROPERTY DAMAGE.
DO NOT INSTALL, DISCONNECT OR PERFORM ANY SERVICE ON THIS EQUIPMENT BEFORE
POWER HAS BEEN SWITCHED OFF OR THE AREA HAS BEEN SECURED AS NON-HAZARDOUS
BY PERSONNEL AUTHORIZED TO DO SO BY THE RESPONSIBLE PERSON ON-SITE.
ONLY THE COMPONENTS SPECIFIED IN THIS MANUAL CAN BE USED IN THIS TERMINAL. ALL
EQUIPMENT MUST BE INSTALLED IN ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS
DETAILED IN THIS MANUAL. INCORRECT OR SUBSTITUTE COMPONENTS AND/OR DEVIATION
FROM THESE INSTRUCTIONS CAN IMPAIR THE INTRINSIC SAFETY OF THE TERMINAL AND
COULD RESULT IN BODILY INJURY AND/OR PROPERTY DAMAGE.
WARNING
WARNING
WARNING
WARNING
®
OPTION (KIT NUMBER 64067252) MUST NOT BE USED IN
WARNING
WARNING
WARNING