Maintenance Schedule - Kärcher CB 2 exclusiv 23 Manual De Instrucciones

Time Activity
daily Check safety installations Emergency-stop button on operating
Check notes for self-op-
eration customers (only
with self-operation
plants).
Check filling level of the
detergent.
Check spray jets for
blockage
Clean light barriers.
Visual inspection
Check brush rollers for
foreign bodies
Check water supply
Function test
weekly or Check condition of the
after 500 washing brushes.
washes
Check hoses and piping
for absence of leakness.
after 1000 Visual inspection
washes
Reset
36

Maintenance schedule

Assembly affected
point for manual mode, wash card/
code reader, all other emergency-stop
buttons in the plant, safety switches in
the small halls.
Signs with operation instructions and
proper use according to the stipula-
tions to be placed at the wash place.
The detergent container is located in
the column on the right when facing
the direction of travel
Jets in the upper section, jet pipes on
the columns and the under floor wash
plant (option), also high-pressure jets
(option)
All light barriers (diagrams 2 and 8)
All limit switches (see diagrams 3 to 6) Check for mechanical damage and stable seat-
Side-brushes, roof brush, wheel
brushes
Rinse and spray circulation
Positioning ramp
Roof brush roll and side brush rolls
Wheel washing brushes
Hoses of the supply line and in the por-
tal
Running rollers of the side-brushes'
wagon (Diag. 7)
Screws for guide rails (roof brush, roof
drier)
EN
Remedy
Start wash programme, activate emergency-
stop buttons or safety switches. The plant must
stop, then press the control supply voltage/nor-
mal position button on the operating point for
manual mode.
Check signs for completeness and legibility. Re-
place damaged signs.
Fill up when required or replace
Make visible inspection (judge spray picture), if
necessary, clean. Warning! Do not mix up jets!
Screw off jets individually, clean with com-
pressed air, screw on again.
Applying gentle pressure, wipe light barriers
with a detergent-free soft, damp cloth.
ing.
Make visible inspection, remove possible for-
eign bodies that are present, clean soiled brush-
es with high-pressure cleaner.
Shut off water in manual operation and check
whether enough water is present in the vehicle
wash. Too little or no water may cause damage
to the vehicle being washed.
Interrupt light barriers "position 1" and "position
2" (see Fig. 2). The positioning ramp must indi-
cate corresponding signal.
Check brush shaft for straightness, check brush
segments on firm seating, check brush for wear
(minimum bristle length: new state minus 50
mm) if necessary, replace.
Replace brushes after approx. 15000 washing
processes. For this: loosen 3 screws within the
bristle ring, remove wheel washing brush, at-
tach new wheel washing brush and fasten it with
the 3 screws.
Visual inspection
Check play by moving the side-brushes. Inform
Customer Service when there is too much play
between roller truck and guide:
Check using a hexagon socket wrench that
screws are firmly screwed in, tighten if neces-
sary (apply approx. 25 Nm tightening torque)
11
-
of whom
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator/
Customer
Service
Operator/
Customer
Service
Operator
Operator/
Customer
Service