GOK LAG 2000 A Instrucciones Par El Montaje Y El Funcionamiento página 47

Figure 5: Electrical power connection of the display unit
Connect the sensor unit
Connect – direct
Fig. 6: display unit can be connected directly Fig 7: display unit can be connected in directly
If the display unit
are installed beside each other, the sensor
cable can be connected directly with the
display unit
part no. 15 071 53 d
and the LDL tank
Leak detector type LAG 2000 A
A1
Light "Operation"
A2
Button "Alarm sound"
A3
Light "Alarm"
A4 Alarm buzzer
A5 Button Test
A6 Nipple for cable lead-through
A Terminal for "power supply"
B Terminal for additional "alarm"
C Terminal for sensor cable
Electrical potential!
Electric shock risk.
Switch off the power supply and make
sure that it cannot be switched on
again inadvertently.
Via terminal "Power" „A".
AC voltage 230V / 50Hz
Use only a fixed connection, not a pug
or switch.
Insert the cable through the nipple.
Connect the cable according to the
terminal block designation.
Connect – indirect
If the display unit
are in different rooms or more than 0,4 m
apart, the sensor cable
extended.
.
and the LDL tank
must be
19 / 28