Start-Up - GOK LAG 2000 A Instrucciones Par El Montaje Y El Funcionamiento

Para la deteccion de fugas en depositos de almacenamiento de combustibles liquides de doble pared, aereos y subterraneos
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Connection relay output for additional alarm – 2nd Display unit as external
alarm
• Another display unit
• Another external alarm can be connected to the display device
display unit

START-UP

Check that the following connections are correct according to ASSEMBLY:
• tank
– LDL tank
• tank
– check valve
• sensor unit
– display unit
• AC power supply
• external alarm
Safety information on leak detector liquid
Before filling with leak detector liquid, read the safety data sheet (SDS) under all
circumstances.
When filling with leak detector liquid, wear safety goggles and gloves under all
circumstances.
If skin or clothing should make contact with the leak detector liquid or a mixture of
the leak detector liquid and water, wash with soap and water without undue delay.
If leak detector liquid should get into the eyes, rinse the eyes with lots of clean
water immediately. Consult a doctor as quickly as possible.
If the leak detector liquid is accidentally swallowed, DO NOT induce vomiting.
Consult a doctor as quickly as possible.
Clear up spilt leak detector liquid and/or mixtures consisting of leak detector liquid
and water as follows: Absorb with a suitable product, and
dispose of through a waste disposal company, stating the components.
part no. 15 071 53 d
unit
as an external alarm for remote signal transmission.
Mounting and electrical connection of the display unit
above for display unit, not attach the front.
display unit
– display unit
– display unit
Leak detector type LAG 2000 A
a can be connected to terminal B Alarm of display
Connect the 2nd display unit
See Figure 8 to connect the cable
of the display unit
Insert sensor cable through nipple
"A6" on the display unit
Attach the cable to 4 and 5
according to the terminal block
designation.
The polarity is unimportant.
If no other additional alarm is to be
connected to the relay output,
replace the front with 4 screws.
Fix the cable to the wall.
a
a.
a as described
a:
: Terminal "C"
a.
21 / 28

Publicidad

Tabla de contenido
loading

Tabla de contenido