Kenmore 385.16644 El Manual Del Propietario página 19

The position of telescoping thread guide bar
i Pull the telescoping thread guide bar up as far as it will
go.
• Turn the thread guide bar until it clicks into position.
Thread guides should stop directly above the spool
pins.
(_ Thread guide
2_ Telescoping thread guide bar
(._ Stoppers
(._) Spool pin
Attaching the spool cap and net
• When you use a small thread spool, remove the spool
holder from the spool pin. Then place the spool with its
slit side up, and put spool cap on top.
Spool holder
Spool cap
@ Slit
Spool pin
• If the thread slips down from the spool during
threading and/or sewing, put a net on the spool as
illustrated to prevent jamming. The nets are supplied
with the machine.
{_} Spool pin
Net
Raising or lowering the presser foot
By raising or lowering the presser foot lifter, the presser
foot goes up and down.
* While in operation, keep the presser foot lowered
except for threading the machine or test running
without thread.
NOTE: Thread tension will be released when the presser
foot lifter is raised.
(j'_)Presser foot lifter ._j Presser foot
f
i\
I !
it
1
I
I
I
! I
I !
t I
I I
t
,/@
1l _, /
I
t t ,,,'-I_
J
18