Kenmore 385.16644 El Manual Del Propietario página 33

• Threading the needle on the right
Place the spool of thread on the spool pin second from
the left.
" Points to thread for needle on the right are marked in
blue.
" A convenient threading chart is placed on the
machine body which is located inside the loope cover.
,1_Draw the thread through the thread guide second from
the left from back to front.
(_ Thread guide
Pass the thread through the holes in the second row
from the left of thread guide plate as illustrated.
(_ Thread guide plate
Hold the thread at both ends and tug gently to ensure
the thread is correctly inserted between the tension
discs.
(If the presser foot lifter is raised, the thread easily
inserts between the tension discs.)
Thread tension dial
After passing through the front cover thread guide (1),
pass the thread from the bottom of the front cover
thread guide (2) and the take-up lever cover from right
to left.
Guide the thread over the front cover thread guide (3).
Insert the thread into the right slot of the guide plate.
_1, Raise the needle to its highest point and pass the
thread through the needle bar thread guide from left to
right.
Thread the right needle from front to back and pull the
thread about 10 cm (4 ") from the eye of the needle to
the back under the foot.
Note: When you pull the needle thread under the
presser foot, be careful not to Wind the thread
around the upper looper.
(_ Front cover thread guide(l) _ Front cover thread guide (3)
_ Front cover thread guide (2) _, Needle bar thread guide
(.._ Take-up lever cover _ Right needle
Guide
plate
32