Kenmore 385.16644 El Manual Del Propietario página 25

e, Hook the thread on the corner _), and then pass the
thread through the thread guide plate and the looper
thread guide.
Pass the thread through the changeable thread guide.
Pass the thread through the looper thread take-up
lever (Lower).
41, Pass the thread through the lower looper thread
guide (1).
_) Thread guide plate
(_ Looper thread guide
(._ Changeable thread guide
[2) Looper thread take-up lever (Lower)
_) Lower looper thread guide (1)
First, bring the lower looper to its extreme right position by
rotating the handwheel toward you. Then lift up the lower
looper thread guide (1). When you do this, the other lower
looper thread guides (2,3) will automatically move up to
make it easier to reach them.
Pass the thread through the lower looper thread guide (2).
Pass the thread through the lower looper thread guide (3).
Holding the tip of the thread, bring the needle bar to its
lowest position by turning the handwheel toward you.
The lower looper thread guide (1) will return to its original
position automatically.
(.._) Lower looper thread guide (1)
6} Lower looper thread guide (2)
(9) Lower looper thread guide (3)
* Make sure that the needle threads are not tangled in
the lower looper.
Move the lower looper to its rightmost position by
turning the handwheel, and draw the thread with a
pair of tweezers through the hole on the lower looper
10 cm (4") or more.
Close the side cover.
_j) Lower looper
f
/
t
/
\
When threading, the lower looper pre-tension setting
slider and the changeable thread guide must be set at the
position as illustrated.
Lower looper pre-tension setting slider
_ Changeable thread guide
l
24