Kenmore 385.16644 El Manual Del Propietario página 45

Adjustment of cutting width
When cutting width is too narrow or too wide for seam
width, adjust as follows.
Turn off the power switch and unplug the machine.
41, Open the looper and side covers.
41, Set the upper knife to down position (refer to page 60).
Turn the cutting width adjusting dial to get desired
position of lower knife.
(A) When cutting width is too narrow:
Turn cutting width adjusting dial clockwise.
Lower knife will move to right,
(B) When cutting width is too wide:
Turn the cutting width adjusting dial
counterclockwise.
Lower knife will move to left,
Set the upper knife to up position.
_1, Close the looper and side covers.
Standard
Est6ndar
(A) Rdgulier
(B)
(A)
44