Function; Signal Configuration - Georg Fischer EA11 Manual Instrucciones

Accessories for electrical actuators

9.2 Function

The positioner type PE25 controls a user-defined valve position proportional to a given
setpoint value. This can be 0-10 V or 4-20 mA. The return of the valve position (actual
value) is realised by means of the position signalization
(Chapter 7). The control parameters have already been preset at the factory and do
not need to be changed.

9.3 Signal configuration

The four DIP switches of a DIP switch block on the controller print are used for the
configuration of the signals.
S1 S2 S3 S4
Fig. 14
ON
OFF
Positioner PE25
69