Georg Fischer EA11 Manual Instrucciones página 80

Monitoring print
 Activate reset switch 9 on the base board or disconnect the actuator from the
mains voltage.
Both LEDs will go out and the actuator is ready to operate.
The ready-to-operate module can react also in fail-safe mode. Resetting the
malfunction message does not reset the set number of cycles!
DIP switch in case of error
With the help of the DIP switch on the power supply unit, the actuator can be moved to
the CLOSED or OPEN position in case of a malfunction.
 For this purpose, set the DIP switch as follows:
DIP 1
ON Position of DIP 2 is effective
Actuator remains in its position.
OFF
DIP 2 is not effective
In case of a malfunction, the actuator
remains in its current position (delivery
state)
In case of a malfunction, the actuator
moves to the OPEN position
In case of a malfunction, the actuator
moves to the CLOSED position
80
Accessories for electrical actuators
DIP 2
Actuator moves to OPEN position
Actuator moves to CLOSED position
ON
OFF
1 2
ON
OFF
1 2
ON
OFF
1 2