Function - Georg Fischer EA11 Manual Instrucciones

Monitoring print

10.2 Function

The monitoring print is mounted to the base board and electrically connected to it on
plug X1 via a flat cable. The monitoring print enables five functions:
1. Cycle time extension
2. Cycle time monitoring
3. Monitoring of a selected number of cycles
4. Monitoring of a selected maximum motor current
5. Position feedback 4-20 mA
These monitor settings are made via the BCD switches 1 to 4. The switches must be
connected for the function to be active. The functions work independently of one
another. 1 to 4 BCD switches can be plugged individually.
The monitoring functions of cycle time extension, cycle time monitoring and
cycle counter are not suited for actuators with controller.
76
Accessories for electrical actuators